Welcome to about book binding your resource
for FREE bookbinding information.
 |  |  |
by Joseph W. Zaehnsdorf
Published in London 1897
Paste Paper and Pasting UP
This kind the binder can easily make for himself. Some colour
should be mixed with past and a little soap, until it is a little
thicker than cream. It should then be spread upon two
sheets of paper with a past brush. The sheets must then be
laid together with their coloured surfaces facing each other,
and when separated they will have a curious wavy pattern on
them. The paper should then be hung up to dry on a string
stretched across the room, and when dry glazed with a hot
iron. A great deal of it is used in Germany for covering books.
Green, reds, and blues have a very good effect. There are
many other kinds of paper that may be used, but the above
five different varieties will give a very good idea and serve as
points to work from. The many bookbinders' material dealers
send out pattern books, and in them some hundreds of
patterns are to be found.
on whole bound work; there must, however, be placed in the book when has been covered. After having decided
upon what kind of paper is to be used, two pieces are cut and folded to the size of the book, leaving them a trifle
larger, especially if the book has been already cut. Two pieces of whit paper must be prepared in the same way.
Having them ready, a white paper must be prepared in the same way. Having them ready, a white paper is laid down,
folded, on a pasting board (any old mill-board kept for this purpose), and pasted with moderately thin paste very
evenly; the two fancy papers are laid on the top quite even with the back or folded edge; the top fancy paper is now
to be pasted, and the other white laid on that ; they must now be taken from the board, and after a squeeze in the
press between pressing boards, taken out, and hung up separately to dry. This will cause on half of the white to
adhere to one half of the marble or fancy paper. When they are dry, they should be refolded in the old folds and
pressed for about a quarter of an hour. When there are more than one pair of ends to make, they need not be made
one pair at a time, but ten or fifteen pairs may be done at once, by commencing with the one white, then two fancy,
two white, and so on, until a sufficient number have been made, always pressing them to ensure the surfaces
adhering properly; then hang them up to dry. When dry press again, to make them quite flat. As this is the first time I
speak about pasting, a few hints or remarks on the proper way will not be out of place here. Always draw the brush
well over the paper and away from the centre, towards the edges of the paper. Do not have too much paste in the
brush, but just enough to make it slide well. Be careful that the whole surface is pasted; remove all hairs or lumps
form the paper, or they will mark the book. Finally, never attempt to take up the brush from the paper before it is well
drawn over the edge of the paper, or the paper will stick to the brush and turn over, with the risk of the under side
being pasted. While the ends are pressing we will proceed with further forwarding our book.
Pasting Up
too much swelling, it must be tapped down gently with a hammer. Hold the book tightly at the foredge with the left
hand, Knuckles down; rest the back on the press, and hit the back with the hammer to the required thickness. If the
book is not held tightly, a portion of the back will slip in and the hollow will always be visible; so I advise that the
back be knocked flat on the "lying press" and placed in it without boards, so that the back projects. Screw the press
up tightly, so that the sheets cannot slip. A knocking-down iron should then be placed against the book on its left
side, and the back hammered against it; the "slips" or cords must be pulled tight, each one being pulled with the
right hand, the left holding the slips tightly against the book so that they cannot be pulled through. Should it happen
that a slip is pulled out, nothing remains but to re-sew the book, unless it is a thin one, when it may possible be
re-inserted with a large needle. But this will not do the book any good.
The slips being pulled tight, the first and last section should be pasted to those next them. To do this, lay the book
on the edge of the press and throw the top section back; lay a piece of waste paper upon the next section about
1/8 or 1/4 inch from the back, according to the size of the book, and paste the space between the back and the
waste paper, using generally the second finger of the right hand, holding the paper down with the left. When
pasted, the waste paper is removed, and the back of the section put evenly with the back of the book, which is now
turned over carefully that it may not shift; the other end is treated in the same manner. A weight should then be put
on the top, or if more than a single book, one should lie on the top of the other, back and foredge alternately, each
book to be half an inch within the foredge of the book next to it, with a few pressing boards on the top one. When
dry the end papers are to be pasted on.
email: info@aboutbookbinding.com